Battery Storage & Maintenance During Periods of Non-Use
Batteries of older design types such as lead-antimony (such as often found on classic vehicles) tend to self-discharge in storage more quickly than more modern lead-calcium or hybrid batteries which retain their charge for several months if stored in a cool ambient.
Fully sealed MF motorcycle batteries (with glass-mat separators) retain charge in storage better than other starter batteries but are more difficult to recover once truly deep-discharged.
The warmer the storage ambient temperature the faster the battery’s tendency to self-discharge. Batteries not in regular use which for any reason cannot be maintained by a good maintenance charger are thus best stored in cold conditions, BUT NOT FREEZING !
Battery manufacturers recommend that engine-start batteries are best kept fully charged at all times. All batteries have finite life-spans, often referred to by manufacturers in terms of duty-cycles. Maintaining the battery fully charged throughout periods of non-use therefore avoids using up some of the battery’s lives. Some chargers sold as “battery conditioners” for medium term maintenance, which charge, stop, then “kick in” again only when a battery has discharged to a certain level, are therefore not recommended. Far better are more advanced chargers such as OptiMate or AccuMate which by a combination of both voltage & current sensing during & following the main constant current charging stage, automatically “double-check” that the battery is truly fully charged at the conclusion of the main (constant current) charging stage & then only proceed into float charge to offer the battery whatever current it needs continuously, thereby ensuring a permanently fully charged battery. The important advantages are firstly that these chargers do ensure the battery IS fully charged BEFORE passing to a (lower voltage limit) float charge mode, and that in this mode it is the battery which signals to the charger and draws from it just the amount of current needed to support the load of alarms, accessories or current leaks in the vehicle wiring.
Only by both current & voltage sensing can truly smart circuitry be sure the battery is fully charged before passing into the lower voltage-limited float charge stage. Sensed voltage alone may indicate a full battery in cases of abnormal resistance due to deep discharge. The OptiMate & AccuMate circuits which monitor both current & voltage, check that the battery does not draw significant current at the 13,8 V Float charge limit during a trial initiation of the maintenance stage, BEFORE fully engaging this stage, (& indicating“battery ready”- green LED). Both chargers thus revert automatically to constant current mode if the monitored parameters indicate that the charging mode has prematurely passed into maintenance mode. This ensures the battery is really ready for the maintenance phase even in cases of an irregular rising voltage characteristic during the constant current stage.
Removal of filler caps of non-sealed batteries connected to an AccuMate or OptiMate is unnecessary.